Published
Every evening, the Central Pollution Control Board (CPCB) releases data collected from multiple air pollution sensors in the country. According to this data, Delhi and surrounding areas remain some of the most polluted in the country all year round, and especially from October to February. However, winter trends show worsening conditions in some of the other parts of the country too. In this story we explore what the CPCB data says about year-on-year changes in the AQI numbers.
The bulletin, along with the visible smog, is a marker of fluctuating air quality in many parts of the country, mainly the national capital region (NCR), during winter months when pollution is known to spike. Every winter, the stories of Air Quality Index (AQI) levels rising make headlines. We decided to look at the winter days’ daily AQI bulletin and filter it in different ways to see how every winter compares with the other.
For a part of this analysis, we collected daily data between October and February for the past four winters – October 2022 to February 2023, October 2023 to February 2024, October 2024 to February 2025, and October 2025 to February 2026.
On October 31, the bulletin provided readings from 288 locations in the country. However, at the same time last year, there were 243 regions in the bulletin. To account for this difference in number of days monitored, we first filtered the data to only consider locations that have been in the system for 95% of the total days considered. So, if a region shows up in the data for at least 574 out of 604 days, it was considered for this analysis.
While Delhi, Greater Noida, Ghaziabad, Noida, and Gurugram formed the top (right-most) of the list, they were followed closely by Bhiwadi in Rajasthan, Meerut in Uttar Pradesh, Faridabad in Haryana, Patna and Hajipur in Bihar, Bulandshahr in Uttar Pradesh, Charkhi Dadri in Haryana, and Hapur in Uttar Pradesh.
All these locations fall in the Indo-Gangetic plain that is locked by the Himalayas on the north side. Multiple studies, like this one, have found that the post-monsoon and winter months have higher aerosol concentration than other months in this region.
“[During winter months], a large-scale decline in the air temperature, significantly shallower atmospheric boundary layer, and weaker winds lead to stagnant conditions (ventilation coefficient lower by a factor of ~4) thereby confining the anthropogenic influences closer to the surface,”
From a 2020 study, ‘On the widespread enhancement in fine particulate matter across the Indo-Gangetic Plain towards winter’
The Himalayas further form a barrier to dispersal of pollutants.
Indo-Gangetic Plain
While Delhi-NCR remains the most polluted, an aggregated look at the daily bulletin also reveals other regions that have witnessed a noticeable trend in winter-time pollution.
Changing the angle of looking at the data reveals another picture. For this next analysis, we filtered locations to not include ones that had missing data for any of the four winters considered for this story. So if data for an entire winter season were missing from a location, it was not considered in this analysis. This revealed some locations to have witnessed an increased AQI, while some regions have experienced a lower AQI over past four years, as per the CPCB data. This trend appears when we aggregated the daily bulletin numbers for the past four winters and calculated the median of each winter before calculating the difference in the median of each winter. This following chart shows the difference between winter of 2022 and 2025.
How much has pollution changed over past four winters?
Where AQI increased
The largest jump was in the industrial town of Nandesari in Gujarat. The AQI there jumped by 159 points between the winter of 2022 and 2025. In Hapur region of Uttar Pradesh, the AQI jumped by 107 points. In Naharlagun, Arunachal Pradesh, it jumped by 83 points, 80 in Charkhi Dadri in Haryana, 76 in Sonipat area of Haryana, 73 points in Mandideep area of Madhya Pradesh, and 58 points in Ballabgarh, Haryana.
It is worth noting that the locations that have shown an increase in the median AQI between 2022 winter and 2025 winter are not limited to the Indo-Gangetic plain. Some of the locations are in regions far away from the plains. The following map shows locations where AQI increased by more than 40 points in the past four winters.
AQI increased in these locations by more than 40 points over past four winters
Where AQI decreased
In some parts of the country, AQI improved over the four winters. According to this data, air quality improved in many parts of Bihar. In some places, the AQI fell by more than 200 points.
Begusarai’s median winter AQI, for example, fell by 269 points, dropping by roughly 90 points each year from 2022–23, when it stood at 385. Other locations where median winter AQI fell by over 200 points include Siwan, Katihar, Bettiah, Purnia, and Samastipur.
On August 25, 2026, the Bihar Pollution Control Board (BPCB) told state environment minister Ram Chandra Prasad that the pollution has decreased in 2025 compared to 2022. The official Facebook page of BPCB shared a news article which claimed that the PM.25 concentration had fallen by 55.15% and the PM10 concentration had fallen by 52.54% in the same period. However, there was no mention of the reason behind such a drastic change in the pollution numbers in parts of the state.
This is what the CPCB data says for Patna, where the AQI fell by 163 points – going from 302 in 2022 winter to 139 in 2025-2026 in the CPCB records.
“Bihar is an Indo-Gangetic state. We also have massive flood plains. Alluvial sand is fine, and even slight air activity contributes to increased particles in the air. That circulation cannot be controlled, but recirculation can be reduced. Plantation helps here. Our green cover has increased and is now over 15%,” said Neeraj Narayan, Member Secretary, Bihar Pollution Control Board.
He attributed the decreased AQI to series of policy decisions including mandating use of clean fuel in industrial and commercial sector with decreased Value Added Tax (VAT) on clean fuel sources, adopting zig-zag technology in brick kilns, increased road surface network to avoid congestion, increased number of sprinklers and dusting sweepers, and end-to-end pavements along roads.
How AQI is calculated
The AQI of a location is derived from readings from a sensor that is part of the Continuous Ambient Air Quality Monitoring Station (CAAQMS). Each station is equipped to record the concentration of seven pollutants, including PM2.5 and PM10. As per the rules set by CPCB, AQI is calculated when there are readings of at least three pollutants, one of which must be PM2.5 or PM10. A station’s reading is also not considered if there are fewer than 16 hours of data out of 24 hours of the day.
“On a filter tape, particulate matter is collected over a predetermined, time-stamped and calibrated period. Beta rays are then passed through the collected spot, and a predetermined algorithm converts the resulting signal into a concentration. The Air Quality Index is a calculated value based on seven parameters,”
Dr Mohan P. George, who previously worked with the Delhi Pollution Control Board
There are 634 monitoring stations in total, according to a document published by the National Air Quality Management System of CPCB on their website. At every station, for 5 out of the 7 parameters, a 24-hour average in µg/m3 is calculated and converted into a sub-index. Two parameters use an 8-hour average. A sub-index is calculated for each parameter using a set formula. Of the seven sub-indices derived from the concentration of respective pollutants, the worst sub-index becomes the AQI of that station, and the corresponding pollutant becomes the dominant pollutant. If a location has multiple stations, the average of all stations becomes the AQI for that location. Delhi, for example, has 59 stations and Mumbai has 26, while places such as Aizawl, Ahmedabad and Bulandshahr have one each.
“In Delhi, and in Northern India generally, PM2.5 or PM10 is usually the dominant pollutant. Seven parameters are used to calculate the AQI, and the highest sub-index is reported as the AQI for that station. The average of the values from all available stations then gives a single AQI for the city,” Dr. George added.
In places with multiple monitoring stations, the AQI reading that appears in the daily bulletin is already an average of all available station readings.
Incomplete data
One filter not applied in this analysis is the number of days for which data was recorded each winter. Ideally, there should be 150-151 days of data per winter. However, in places like Nandesari, Begusarai, Naharlagun, Imphal, Darbhanga, etc., there are days when the data is missing. The issue is common, and more widely discussed in Delhi, where gaps in stations’ hourly monitoring are often noticed. In Bihar’s Darbhanga, which had a median AQI of 358 in the winter of 2022, was missing from CPCB data from the following winter until October 14, 2026, when it resumed reporting. In Nandesari, an industrial town in Gujarat, the data is often found to be incomplete. From the days that it did record data, the AQI looked to have increased significantly. In Imphal, Manipur, which is one of the only two locations to have recorded a 500 AQI (October 7, 2024) in the past four winters, weeks of data were found to have been missing. The other location that has recorded a 500 AQI is Gadag in Karnataka on December 10, 2022. The district that otherwise maintains a good category AQI had four days of spike in AQI in 2022. In the winter of 2025-2026, months of daily data were missing.
One of the requirements, according to CPCB, for daily data to be valid is that the station has to monitor data for at least 16 out of 24 hours. The last page of the daily bulletin also lists locations, some with multiple monitoring stations, where data is not published due to insufficient data. Multiple requests for comment from the CPCB officials about the most common reasons for insufficient data went unanswered. In the 304 days between January and October 2026, 21 locations had insufficient data on 200 or more days.
There are several limitations, and several reasons why granular data does not appear in the public domain. However, understanding what is available in the public domain can help people ask better questions of those elected to offices that can act on air quality.















